Product Overview
This A229900008853 electronic accelerator pedal (model PS0831S) is a precision throttle control component built for upper-cab operation on Sany mobile truck cranes paired with Cummins Stage III engine systems. Designed as a direct drop-in replacement for original equipment, it converts the operator’s foot input into stable, linear electrical signals that are sent to the engine control unit to regulate engine speed and power output. The unit is engineered specifically for heavy-duty construction and lifting environments, delivering consistent response and long-term reliability under demanding site conditions.
Design & Performance Features
The pedal uses a contactless Hall-effect sensing mechanism, which eliminates internal physical friction and wear compared to traditional contact-type pedals. This design greatly extends service life and maintains signal accuracy over years of operation. It is configured with dual-channel redundant signal output — a standard safety requirement for lifting machinery — that ensures the system can still operate reliably even if one signal circuit experiences an anomaly. The pedal housing is made of reinforced engineering plastic with a heavy-duty steel mounting bracket, built to resist constant vibration, dust intrusion, and moisture exposure on job sites.
Contactless Hall sensor technology for zero internal wear and stable signal output
Dual redundant analog signal channels for improved operational safety
IP65 protection rating against dust and low-pressure water spray
Wide operating temperature range from -40℃ to 85℃ for all-climate use
Complies with ISO 7637 / ISO 11452 EMC standards for electromagnetic interference resistance
Validated for over 2 million operating cycles for long service life
Factory-calibrated signal linearity within ±2% for precise throttle control
Technical Specifications
| Operating Voltage | 5 ± 0.1V DC |
| Signal Output Range | Channel 1: 1.1~4.2V; Channel 2: 0.55~2.1V |
| Operating Current | ≤ 25mA |
| Mechanical Rotation Angle | 15° |
| Overvoltage Protection | 16V DC (sustained 60 minutes) |
| Reverse Polarity Protection | -16V DC (1 minute) |
| Wiring Harness Length | 800mm |
| Load Rating | 10kΩ, 4.7μF |
Application & Compatibility
This electronic throttle pedal is engineered to match the original mounting dimensions and electrical connector specifications of Sany truck crane upper cab controls. It requires no wiring modifications during installation, reducing maintenance downtime. It is compatible with Sany mobile crane models equipped with Cummins III-B engines, including but not limited to the STC250 series, STC500, STC750, and QY series truck cranes. It serves as a functional equivalent to cross-reference part numbers JP0831S and JPS0831S.